How can it all take so long?

Well, I dunno, but it does.  I have but a paltry collection of photos to show you: little indeed for the hours that I've been putting in during the three weeks since last I posted.  All I can say is that I've been working long days and there isn't much to show for it.  Still, one day I'll get there!

 With the dividers filleted in place, I made framework for the lids/seats to land on.  As ever, things didn't go perfectly as anticipated, so there was a certain amount of sanding or filling to be done to get everything level so that the lids don't wobble.

 In the meantime, I finished off in the lazarette, making a removable sole panel which is at a little less of a steep angle than the bottom of the boat.  The idea is that it will be a little less uncomfortable to sit there when I am getting things out of the lazarette.

 Belatedly, I recalled that I had intended to make a bar either side, to keep the boxes in place.  Actually, there is not much headroom for them and the fiddle on the shelf is quite high, so they are very unlikely to jump out of their own accord.  Still, if they can, they will!  It would have been a lot easier to fit before I closed in the cockpit!

 The seat framing is glued into place and the screw holes plugged.  (I often find it quicker to use wood plugs for screw holes than to fill them with epoxy.)

 Before I painted the lockers, I cut up strips of decking for slats, in the hope of preventing things in the locker from standing in pools of water.

 I then masked off for the slats and proceeded to paint the lockers with four coats of low-sheen, two-part polyurethane paint.

 I stopped painting when the lockers looked white!

 Pulling the masking tape off was a satisfying job.  The locker is now ready for the teak slats.

 I am trying to fit a nice teak capping to the outboard motor transom.  My thicknesser stops at about 4 mm.  I sanded the teak some more, but it's still rather too thick to bend easily.  Using a silly number of screws and heating the teak with a heat gun, I managed to force it into place.  I will leave it there for a couple of days, but I have no great hopes that I will be able to glue it back in again without it breaking.

 A little bit of teak trim around the cockpit gives a pleasant illusion of solid teak.  I happened to have a long length that I'd made up for the forward end of the centre deck, but which had broken when I tried to bend it too far.  It was made from recycled timber with old screw holes plugged.  This recycled timber will now be recycled again.  Teak is inconceivably expensive and I can't even consider buying any new.

I don't think I've included a photograph of the little rail next to the fire.  It does a good job (assuming it doesn't delaminate due to the heat!), but is still awaiting the varnish brush.

And finally, I have managed to paint around the galley hatch.  I was waiting for the final use of the low-sheen paint to do this.  I'm pleased I remembered - I don't see my using that paint again.  Which is a nice feeling!